Egg Turning Connection for Single Direction Rotation Motor

Posted by 德明 邱 on

This article introduces egg turning connection for single direction rotation motor.

The egg tray photo:

 

 

Connection method 1:

Only connect “turn left output” to motor:

Motor speed: 2.5 rpm, = 2.5 / 60 second, = 0.5 / 12 seconds

Setting:

    Stop for 45 minutes (For ZL-7918A, it is F1)

    Motor running for 12 seconds (For ZL-7918A, it is F2)

Remark:

    After 45 minutes, the right output will run for 12 seconds; after 45 minutes, the left output will run for 12 seconds.

    Result: every 90 minutes, the left output will run for 12 seconds.

    Since there are no position switches, and every motor is not same in speed, and a motor speed will change under different condition, thus, when the position is not very correct, make use of “manual turning” function to adjust the position.

   Also try 9, 10, 11, 12, 13, 14, 15 seconds for best position.

Connection method 2:

Add 2 position switches to test the position of egg. Connect both “turn left output” and “turn right output” as shown. 

Motor speed: 2.5 rpm, = 2.5 / 60 second, = 0.5 / 12 seconds

Setting:

     Stop for 90 minutes (For ZL-7918A, it is F1)

     Motor running for 24 seconds, much bigger than 12 seconds (For ZL-7918A, it is F2)

Remark:

     Every 90 minutes, there will be on egg turning.

     It is unnecessary to adjust the position.

    

Victor

2018-9-11

 

0 comments

Leave a comment